The difference between the use of eye guide rod and no eye guide rod

Use without a guide pole

1. Take off the fishing rod peg and pull out a little of the fishing rod tip.

2. Remove the fishing rod from the tip section one by one, and twist a little to tighten it every two sections.

3. When collecting the rod after use, it must be recovered from the tail section one by one. When collecting the rod, the chimera of the two rods can be twisted with both hands a little, which is chimeric loose

Move. Then the details are collected into the coarse section. When collecting the rod, it is necessary to gradually use force to experimentally collect it. Do not suddenly use force to collect it, otherwise it may cause hand injury. When collecting the rod, it must be gradually collected from the tail section, otherwise if the tip details are included first, the details may fall into other thick sections, resulting in damage to the fishing rod.

Use of eye guides

1. Remove the protective cap of the eye guide, and then pass the fishing line (bus) from the large eye guide to the middle of the small top ring eye guide.

2. The fishing rod is pulled out in the order of taking it out one by one from the tip, and the chimera of each two sections can be slightly twisted to tighten it.

3. After the rod is completely pulled out, the eye guide ring should be arranged in a straight line.

4, after use, the rod should be recovered from the tail rod section by section.